# Timing Grouped Mean Calculation in R

This note is a comment on some of the timings shared in the dplyr-0.8.0 pre-release announcement.

The original published timings were as follows:

With performance metrics: measurements are marketing. So let’s dig in the above a bit.

These timings are of the kind of small task large number of repetition breed that Matt Dowle writes against. So they at first wouldn’t seem that decisive. Except, look at the following:

• At the time of our reading the example and methods were not shared. To reproduce the work we will need to make our own example (which we share here).
• The timings are not relative to any other package or system (base-R, data.table, and Pandas being three obvious choices), so may have trouble valuing the results.
• The time reported for dplyr on the sum()/n() examples is over a second to process 10,000 rows. This is unbelievably slow, and we fail to reproduce it in our run.
• The time reported for dplyr on the mean() examples is about 0.01 seconds. This is a plausible time for this task (about 3 times as long as data.table would take). But it is much faster than is typical for dplyr. We fail to reproduce it in our run, we see dplyr taking closer to 0.06 seconds on this task (or about five times slower).

Let’s try to reproduce these timings on a 2018 Dell XPS 13 Intel Core i5, 16GB Ram running Ubuntu 18.04, and also compare to some other packages: data.table and rqdatatable.

In this reproduction attempt we see:

• The dplyr time being around 0.05 seconds. This is about 5 times slower than claimed.
• The dplyr sum()/n() time is about 0.2 seconds, about 5 times faster than claimed.
• The data.table time being around 0.004 seconds. This is about three times as fast as the dplyr claims, and over ten times as fast as the actual observed dplyr behavior.

However, Matt Dowle is also right: comparing at this scale doesn’t tell half the story we see when we try to summarize 10,000,000 rows down to 1,000,000. At this scale data.table still takes under half a second (time not much worth arguing over), yet dplyr takes 10 to 24 seconds! Or that dplyr is no faster than base::tapply() (despite many claims to the contrary).

All code for this benchmark is available here and here.

Tags: